PCD Grinding Segment With 30 Grit Bar

The 37 Series PCD with Bar Tooling is a top - notch solution for coating removal. It has two offset 3/8 - inch wide PCD diamonds along with an angled 30 - grit Hard Bond Metal Bar. These Polycrystalline Diamonds (PCD) are highly resistant to heat and fractures, making it an excellent tool for stripping coatings. This tool is designed with the 30 - grit bar to prevent deep scratches and gouges while aggressively taking off the coatings. It's the go - to choice when prepping for a final polished floor or a stained and sealed floor. It's the fastest way to remove coatings over 2 mils thick without using harsh chemicals or messy shot - blasting methods. Both the Double and Single Bar PCDs can withstand high heat and resist fractures well.

Using this PCD grinding segment is quite straightforward. First, make sure your machine is suitable for this tool and is properly set up. Attach the segment securely to the machine. When starting to remove coatings, move the machine steadily over the surface. This tool is great for removing coatings over 2 mils thick. But remember, don't press too hard on the surface as the 30 - grit bar is designed to prevent deep scratches. When you're done using it, clean the segment thoroughly to remove any debris. Store it in a dry place to avoid rusting. Periodically check for any signs of wear on the PCD diamonds and the metal bar. If you notice excessive wear, it might be time to replace the segment.