Carbide Tipped FlexiBit Flexable Shank

Tru-Cut's Masonry Bellhanger Drill Bits, proudly made in the USA! These bits feature a wire - pulling hole in the flute. Ideal for various masonry jobs with a specific bellhanger diameter.

Using these drill bits is easy. First, choose the right bit for your job based on the required diameter. Then, attach the bit to your drill. Start drilling at a slow speed to get a proper start and then gradually increase the speed. When drilling, apply steady pressure but don't push too hard. After use, clean the bit with a brush to remove any debris. Store the bits in a dry place to prevent rusting. Also, make sure to wear safety goggles and other appropriate safety gear when using these drill bits.