Cobble Impregnator CP is an eco - friendly, water - based, clear breathable sealer with super low VOCs. It's designed to protect natural stone, interlocking pavers, and concrete surfaces. This sealer gives a natural, sheen - free look, making it perfect for protecting surfaces without altering their appearance. Its breathable formula allows application in places where film - forming sealers won't work, like over clay bricks or on moisture - retaining surfaces. Each gallon can cover about 200 square feet per coat, and a 5 - gallon container can cover around 1,000 square feet. Coverage varies based on surface porosity, joint width, and application method. It can protect against stains, water, and sun damage, and is suitable for use on concrete, marble, pavers, stone, and porous tile. It can also be used as a brick paver sealer or stone sealer. However, it's not for sealing stucco cracks. Before applying, remove all grease, oil, and contaminants. The surface must be clean and dry. Concrete should cure for at least 28 days, and smooth concrete needs etching. Use a roller or sprayer for application, and remove excess product within 15 minutes. Read the label thoroughly before use.


How to use: First, make sure the surface is clean and dry. Remove any grease, oil, or other contaminants. If it's concrete, let it cure for at least 28 days, and etch smooth concrete. You can use Cobble Clean and Cobble Prep for specific cleaning. Apply the sealer in one uniform coat with a roller or sprayer. Remove any excess or puddled product from the surface within 15 minutes of application or before it dries. If you need to recoat, do it while the first coat is still wet. Notes: Always read the label thoroughly before using the product. Don't use it to seal cracks in stucco. Maintenance: The sealer offers long - term protection, but you may need to re - apply it depending on the surface's wear and exposure. Keep an eye on the condition of the sealed surface and re - seal as necessary.