The Cobble Enhancer is a penetrating sealer that's perfect for medium to dense porous surfaces like natural stone, interlocking brick pavers, or porous tiles. It creates a stunning wet look without any sheen. This enhancer forms a powerful barrier that resists moisture, stains, and oil. It's non - yellowing and breathable, making it ideal for exterior use on porous stone, brick pavers, and concrete. For best results, apply liberally with a brush or roller, saturating all areas. Let it stand for 3 to 5 minutes and remove excess before it dries. One coat usually does the trick, but you might need two depending on the porosity of the surface. It takes 24 - 48 hours to fully cure. Always read the label before application.
Here's how to use the Cobble Enhancer. First, you can use a brush or a roller to apply it generously on the surface, making sure all areas are covered. Let the product sit on the surface for about 3 to 5 minutes. Before it dries, remove any extra puddles of the enhancer. You can either roll the excess back or wipe it with an absorbent cloth. Usually, one coat gives the best results, but if the surface is very porous, you may need to apply a second coat. It'll take 24 to 48 hours for the enhancer to fully cure and show its full effect. Remember to read the label carefully before you start applying the product. For maintenance, just keep an eye on the surface. If you notice the wet look starting to fade or any signs of staining, you can re - apply the enhancer as needed. This product is great for exterior use, so it can handle normal weather conditions, but try to avoid applying it in extreme heat or cold.
