FXA50A4 High-Cycle Concrete Vibrator

The FXA50A4 High-Cycle Concrete Vibrator is a top - notch tool for working with low - slump concrete. It comes with a 2 - foot head, a 13.1 - foot hose, and a 33 - foot cord, operating at 180 Hz. High - cycle vibrators are essential for low - slump concrete, as they deliver consistent power to work stiff mixes into corners and around rebar, and to remove air pockets. This vibrator uses a three - phase motor at 180 cycles and needs a special GDP5H high - cycle generator. It retains 95% of its power under load. Powered by a 4.5 - amp electric motor, it features permanently lubricated oversized head bearings for long - lasting durability. The hose can be extended up to 45 feet (13.5 meters), and it has a waterproof control box. Optional 50 - and 100 - foot (15, 30 meters) extension cords are also available.

Using the FXA50A4 High - Cycle Concrete Vibrator is easy. First, make sure you have the GDP5H high - cycle generator ready. Connect the vibrator to the generator. Once it's powered on, you can start using it to work on your low - slump concrete. Insert the 2 - foot head into the concrete to work the mix into corners and around rebar and to get rid of air pockets. Remember, this vibrator is designed for low - slump concrete, so don't use it with other types of concrete. When not in use, keep it in a dry place because it has a waterproof control box, but it's still a good idea to protect it from extreme weather. The head bearings are permanently lubricated, but you should check the hose regularly for any signs of wear and tear. If you need to extend the reach, you can use the optional 50 - or 100 - foot extension cords. And if you want to increase the hose length, you can extend it up to 45 feet.