The Metabo KFM 15 - 10 F (601752620) is a top - notch metal bevelling tool with a metal carry case. It's perfect for weld seam preparation with chamfer heights up to 10 mm. The one - touch controller allows for easy, tool - free cutting depth setting in 0.1 mm steps, and has stop points for quick setup and protection during work. You can precisely set the chamfer angle using the guide plate. Its universal carbide burr with three inserts works for all chamfer angles from 0 - 90°. The large - surface guide plates ensure controlled work, and the stop roller helps with pipe guidance. The bail handle adjusts without tools for secure guiding. It features a long - life motor with patented dust protection, Tacho - Constamatic (TC) - Full Wave Electronics for fast work, and electronic overload protection, soft start, and restart protection. Metal sheet sides protect users from chips. Note: The machine may vary in equipment and details. Check delivery scope and product description. Accessories are included only if listed. Parameters: No - load speed 12500 RPM, 13 AMPS, rated input power 1500 W, output power 810 W, chamfer edges, max. chamfer width 45° 9/16 ', max. chamfer height at 45° 3/8 ', grade cutting depth setting 0.1 mm, curvature smallest exterior Ø 2 15/16 ', weight (without power cable) 10.8 lbs, cable length 157 1/2 '. Noise emission: sound pressure level 92 dB(A), sound power level (LwA) 103 dB(A), uncertainty of measurement K 3 dB(A).
Using the Metabo KFM 15 - 10 F bevelling tool is easy. First, set the cutting depth using the one - touch controller. You can adjust it in 0.1 mm steps, and the stop points will help you set it quickly. Next, use the guide plate to set the chamfer angle. When working on pipes, use the stop roller to guide the tool along. The bail handle can be adjusted without tools for better control. Make sure to check the delivery scope and product description for accessories. During use, the machine has electronic overload protection, soft start, and restart protection, so you don't have to worry too much. For maintenance, keep the motor clean as it has patented dust protection. Also, check the carbide burr regularly. If it's worn out, replace it. And always pay attention to the noise emission. If you find the noise too loud or there are any other abnormal situations, stop using the tool immediately and check it.
