The No-Spin Edger is a game - changer for polishing and refinishing. It effectively eliminates vertical surface damage. This rigid aluminum backer comes with built - in vertical surface protection. You can achieve fast and precise cut patterns along edges and in corners, which is much faster and easier than traditional backer pads. It reduces time, labor, and worker fatigue. The patented design features a free - floating top disk with a built - in bumper that stops spinning while the polishing pad works beneath it. Available in three sizes (4', 5', and 7') with either 5/8 - 11 standard threads or M14 metric threads for various applications. An accessory, the 4' Low - Profile Bumper (part # 4139 - LPB), protects faucet fixtures and lower - profile vertical surfaces. Made of aluminum, stainless steel bearing, rubber, and hook - and - loop fastener, it's a durable and cost - effective solution.
Using the No - Spin Edger is easy. First, choose the right size and thread type according to your needs. Attach the edger to your polishing tool. When you start polishing or refinishing, place the edger against the edge or corner. The built - in bumper will stop spinning, protecting the vertical surface from damage while the polishing pad does its job. Make sure to use it on appropriate surfaces. After use, clean the edger with a mild detergent and a soft cloth. Store it in a dry place to prevent rusting. Check the bearing and rubber parts regularly for wear and tear. If you notice any damage, replace the parts immediately to keep the edger working at its best.
