2-Part Epoxy Dispenser Gun - 300ml + 300ml

This trusty red caulk gun is an ideal choice for all your sealing tasks. Its comfortable handle allows you to dispense a consistent bead of caulk with little effort. It's a must - have tool that helps you finish the job right and fast. Key features include a 2 - component design, 300ml + 300ml cartridges, a 1 to 1 mix ratio, and a 26 to 1 thrust ratio drive. Specifications: For the dual - component 300ml + 300ml setup, the plungers are 39.5mm x 39.5mm with 3 steel rods. The mix ratio is 1 to 1. A case contains 10 units and weighs 38lbs.

Using this epoxy dispenser gun is easy. First, load the 300ml + 300ml cartridges into the gun. Make sure they fit snugly. Then, hold the gun by its comfortable handle. Squeeze the trigger gently to start dispensing the caulk. Keep a steady hand to get a consistent bead. When you're done using it, clean the gun right away. You can use a suitable solvent to remove any remaining caulk. Store the gun in a dry place. Also, be careful when handling the cartridges as the epoxy can be sticky. If you have any issues, don't hesitate to reach out for support.