Stone Sealer for Sealing and Protecting Limestone, Granite, Marble, Slate and Other Natural Stones
Features and Benefits of Stone Sealer:
- Advanced micro - bond penetration for top - notch protection
- Heavy - duty stain resistance for all types of stains
- Easy stone cleaning
- Preserves the natural appearance of stones
- Water - based low - solids coating
- Suitable for both interior and exterior use
Where to Use
Natural stones like marble, granite, limestone, slate, terrazzo, travertine, and sandstone.
Directions
First, test in a small hidden area and wait 24 hours to check application ease and results. Let new grout cure for at least 72 hours before applying. Ensure the surface is clean, dry, and free of waxes and coatings.
1. Mask and protect baseboards or nearby areas to avoid splashing.
2. You can apply the sealer to damp surfaces one hour after removing standing water.
3. Use a paint pad, low - pressure chemical - resistant sprayer, roller, or brush to apply an even coat generously.
4. Let the sealer soak in for 15 - 30 minutes. Spread any excess for even penetration and then wipe with a clean dry towel.
5. Porous surfaces may need a second coat 30 - 40 minutes after the first application, following steps 3 - 4.
6. After the final application, wait at least 15 minutes and wipe off excess sealer. Use a damp white nylon pad if there's residue and dry thoroughly.
7. It fully cures in 24 - 72 hours. You can have foot traffic in 6 - 8 hours. Use red rosin paper if you need foot traffic earlier.
8. Clean your equipment with water.
Available Sizes (and Coverage)
- Quart: 50 - 400 sq. ft.
- Gallon: 200 - 1,000 sq. ft.
- 5 gallons
Expected Wear: 3 - 5 years on interior surfaces and 1 - 3 years on exterior surfaces.
Please note that air shipping is not available for this item.
This StoneTech heavy - duty stone sealer is great for protecting natural stones like marble, granite, and limestone. Before using, test it in a small hidden area and wait 24 hours. Let new grout cure for 72 hours. Make sure the surface is clean and dry. Protect areas you don't want to treat. You can apply it to damp surfaces an hour after removing standing water. Use a paint pad, sprayer, roller, or brush to spread an even coat. Let it soak in for 15 - 30 minutes, spread the excess, and wipe it off. Porous surfaces might need a second coat. After the final application, wipe off the excess. It fully cures in 24 - 72 hours, but you can have foot traffic in 6 - 8 hours. Use red rosin paper if needed. Clean your tools with water. It lasts 3 - 5 years indoors and 1 - 3 years outdoors. And remember, air shipping isn't available for this product.
