Paver Enhancing Sealer is a versatile solution for most concrete pavers, cement tiles, terrazzo floors, and cement surfaces. Suitable for both indoor and outdoor use in residential and commercial buildings, this sealer offers numerous benefits. It's made for man - made stone pavers, provides intense color enrichment along with oil and water repellency. It fully impregnates the surface without any sheen. Plus, it doesn't affect the slip rate as per ANSI 37.1 testing. The sealer contains Hexyldecyltrimethoxysilane, methanol, and dimethicone with a VOC content of < 200g/L. Available in pack sizes of 32 fl oz/.95 L, 1 gallon/3.79 L, and 2.5 gallon/9.46 L in the USA, Europe, and Australasia.
Using this Paver Enhancing Sealer is easy. First, always test the product on a small area and wait 24 hours to see the results. Make sure the surface you want to treat is dry, clean, and free of residues, and the temperature is between 40 - 95°F (5 - 35°C). You can use a low - pressure hand sprayer, foam roller, or similar applicator to apply one or more even coats. Try to avoid getting it on surrounding areas. You can apply additional coats every 30 minutes. The estimated application rate is 1 quart per 80 sq. ft. (8 sq. m.), but this can change depending on how much the surface absorbs and how many coats you apply. After 30 minutes, remove any excess and you can apply a second coat. If you spray the product, you must back - roll it into the surface within 30 minutes for all coats. Clean your equipment with acetone. Keep the surface dry (like from rain) for at least 12 hours. You can use the surface carefully 12 hours after application. When applying on vertical surfaces, apply 3 to 4 light coats instead of 2 generous ones, applying each coat before the previous one dries. Place a tarp below to catch drips. Remember, this sealer won't prevent damage from acidic liquids or normal wear. The level of enhancement depends on the material. It's a good idea to test on a sample first. Over time, wear, tear, and cleaning will affect its performance, so you'll need to re - apply it. Once the surface is enhanced, it can't go back to its original look. Store the sealer in a well - ventilated, cool, and locked place. In case of fire, use alcohol - resistant or normal protein foam to put it out.
