FORCE3 Diamond Chain, 10 in (25 cm)

The FORCE3 Diamond Chain is a fast-cutting and cost-effective choice for daily use. It fits a 10' GC guidebar on 680ES-GC gas saws. This 10-inch/25 cm chain with 50 drive links is perfect for cutting light to medium aggregates and rebar.

Product Details

• Ideal for cutting light to medium aggregates and rebar
• Fast and economical for daily jobs
• Optimized for general cutting tasks
• 10' diamond chain

Diamond Chains

Use on Saw Type	Gas Saw/GC drive sprocket
Use Application	Asphalt Brick Block Concrete Masonry Stone
Chain Length	10 in (25 cm)
Number of Drive Links	50.0
Chain Pitch	3/8

General

Unit of Measure	Each

Using the FORCE3 Diamond Chain is easy. First, make sure your 680ES - GC gas saw has a 10' GC guidebar. Install the chain properly on the guidebar and ensure it's tightened correctly. When using, start the saw and let it run at idle for a bit. Then, gently apply the chain to the material you're cutting, like asphalt, brick, or concrete. Keep a steady hand and let the chain do the work. For safety, always wear protective gear such as goggles and gloves. After use, clean the chain with a brush to remove any debris. Store it in a dry place to prevent rust. If you notice the chain is not cutting as effectively, it might need to be sharpened or replaced.